C\ Gabiria nº 112-114-146 Pº Ventas
20305 Irún (Guipúzcoa) SPAIN
Tel.: +34 943 633 562 | Fax: +34 943 633 285
E-Mail: conatec@conatec.com

C\ Gabiria nº 112-114-146
Pº Ventas 20305
Irún (Guipúzcoa) SPAIN
Phone. +34 943...  see telephone
Fax. +34 943...  see fax
E-Mail: conatec@conatec.com



Reguladores PID CN300Self-tuning PID Controller

Temperature regulator set-up by keyboard designed for all processes which require actions on contactors, servovalves without feedback and continuous outputs.

General Characteristics

  • PID control with self-tuning or ON-OFF with hysteresis.
  • Permanent display of the variable and its setpoint.
  • LED display the control output action.
  • Input type configurable by keyboard for thermocouples J, K, S and Pt100 thermoprobes and current inputs 0-20 mA, 4-20 mA, 0-10v or 2-10 v.
  • Control action type configurable by keyboard:
    - Via relay direct or inverse.
    - Via relay for servo-motor without feedback.
    - Analogue 0/20 mA. 0-10v.
    - Analogue 4/20 mA. 2-10v.
  • Absolute, relative or band configurable alarm for the control outputs via relay and analogic.
  • Adjustment of the measurement offset.
  • Output 0/4-20 mA image of the input signal when not using analogue control.
  • Auxiliary power supply for two-wire transmitters.
  • Automatic - manual station.


  • Power supply 230 Vac +/- 10%. Consumption 8 VA.
  • Maximum load for outputs mA with 500 ohm.
  • Maximum consumption for outputs 0/2-10 v with 10 mA.
  • Potential-free relay outputs with cut-off capacity 5A/230Vac in a resistive load.
  • Protection against sensor break.


  • Format 48x96. Panel cut-out 44x92 + 0.8 mm.
  • Depth 140 mm including the connection terminals.
  • Front protection IP54.
  • Rear protection IP20.
  • Operation between 0 and 60ºC and between 0 and 80% of RH.
  • Storage conditions between 10 and 60 ºC.


Attached archives:

We use our own and third party cookies, for the analysis of user navigation. If you continue browsing, we consider that you accept the use.
You can change the settings or get more information here.